Wall Mount Instructions
When you receive your new Wall Mount you should have the following items.
1 Wall Mount (A)
1 Cinch strap (B)
1 or 2 mounting tubes (based on model) (C)
1 mounting tube with indentions (for non oem quick release) (D)
2 Lag Bolts with washers (E)
INSTALLING THE WALL MOUNT (A)
To install your new EZ mount you will need to find the center of the stud you plan to install on. It is HIGHLY recommend that you use a drill and pre-drill the holes this will help to insure that the lag bolts (E) go straight into the stud. Once you have your holes drilled you are ready to hang the wall mount (A).
NOTE: it is very important that you find the center of the stud to screw into. If you get to far away from the center of the stud this could cause the lag bolts (E) not to hold properly. BOTH lag bolts must be used for proper installation.
Once you have the EZ mount properly installed onto the wall you will need to ready the tour pack to mount.
Take one tube (C) or (D for non oem) and install onto the rear quick release of the tour pack. The second tube (C) will be held in place via the cinch strap (B) to the front quick release mount slots of the tour pack. Once you have these tubes in place you are ready to hang the tour pack onto the EZ mount.
PLACING THE TOUR PACK ON THE EZ MOUNT:
The front of the tour pack must be facing down. The tube in the rear quick release will be facing the EZ mount and will simply rest into the top slot of the EZ mount. The tube installed onto the front mounts will rest against the front of the EZ mount.
EZ mount with accessory holder (EZWM102513)
When hanging a windshield or backrest you will attach one mounting tube (C) into quick release and simply hang in the bottom slot on EZ mount.
401 SWINGING BRIDGE ROAD
OLD HICKORY, TN 37138
All prices are in USD.